|
Model HT7010 is very light before the work, t to it automatically determines, being based on the measured signal, the type of measurements and their range. In this case it is not possible to carry out any actions, which lead down the damage of instrument and operator. HT7010 - this is the first small before the size instrument with maximally induced number 6 000. These tongs are created for measuring the relatively low values of alternating current to 400 A with the built-in function of the retention of the measured value on the display. Tongs HT7010 automatically are disconnected with not their use for the safety of small battery. The maximum diameter of seizure 27 mm. the sizes of tongs are small, but it is very functional. Wires are stored in the section on the rear panel of instrument.
Functions
- the measurement of alternating current (IAC) and of voltage (VAC)
- the measurement of DC voltage (VDC).
- the resistance
- the test of electrical conductivity with the automatic interrupter
Delivery set Keys, [Provod], [Rukovodstvo] and the small battery
Standards CE of mark, EN 61010-1
General characteristics
|
Display |
[ZHK] 3 ¾, the analog scale |
|
Rate of the measurement |
1,5 ism/flogged |
|
Nourishment |
1 small battery, 9 [v] |
|
Time of the service of the small batteries |
about 200 hours |
|
Size |
275 * 90 * 51 mm |
|
Ø of the seizure |
51 mm |
|
Spread of the seizure |
53 mm |
|
The operating temperature |
0… 40 °[S] |
|
Humidity |
not more than 75% |
|
Storage temperature |
-20… +60 °[S] |
|
Safety accordingly |
EN 61010-1 |
|
Isolation |
[sat] 2, dual |
|
Pollution |
level 2 |
|
Category |
CAT III 600V between the entrances, |
|
|
CAT OF THE III 600 V to the earth |
Current page:
[NT]7010 |