Instrument measures the impedance, using a wide frequency band or DC, it is simple before the use. It possesses the wide set of the carried out functions with the small cost.

• High rate of the measurements: 5 ms
• High frequency band (DC or from 1[mGts] to 100 kHz)
• Fourteen measured parameters (high accuracy and permission)
• Measurement of the resistance OF DC

Specification

Measured parameters	|Z|, |Y|, The angle of displacement of phases -Θ, Rp (DCR), Rs (ESR, DCR), G, the X, B, Cp, Cs, Lp, Ls, D (coeff. of scattering or the loss tangent), and Q
Method of the measurements	Source: direct current from 10 µ to 100 mA (AC/DC) or constant stress from 10 mV to 5 [v] (AC/DC) Detection: stress, AC or DC
Nominal frequency	DC or from 1 MHz to 100 kHz
Ranges of the measurements	|Z|, R, THE X: from 10 m to 200.00 M[Om] (it depends on conditions), Phase angle: from -180.00 to +180.00 °, C: from 0.3200 pF to 1.0000 F, L: from 16.000 NH to 750.00 kH, D: from 0.00001 to 9.99999, Q: from 0.01 to 999.99, |Y|, G, B: from 5.0000 nS to 99.999 S
Basic accuracy	|Z|: ± 0.08% of measuring. value, the phase angle: ± 0.05 °
Time of the measurements	From the rapid: 5 m s. to [medlennogo]2: 828 m s.
Display	[ZHKD], with the illumination, swing. induced number 99999
Function of the comparator	Installations: upper and lower limits, percent relationship is absolute value. Output: 3 levels (Hi, In, Lo), or (Pass, Fail), the open collector, locked.
External printer	9442 (to use with 9443-02 or -03/9446/9593-01)
Power source	From 100 to 240 [v] AC (50/60 Hz)
Sizes and the mass	125 mm altitudes × of 313 mm latitude × 290 mm of thicknesses. Mass: 4.5 kg.
Accessories	Safety device (1), power cord (1)

3522-50 L[S]R TESTER cannot be used without the options. For the measurements one of the options is necessary: 9261 either 9262 or 9140

Options
9140 four-terminal tester (DC to 100 kHz)
9143 tongs tester (DC to 5 MHz)
9261 test adaptation (with the coupling cables, DC to 5 MHz)
9262 test adaptation (with the direct connection, DC to 5 MHz)
9263 thermisters is temperature sensors (with the direct connection, DC to 5 MHz)
9268 DC voltage node is of displacement (± 40 [v] DC swing.)
9269 DC the unit of bias current (± 2 A DC swing.)
9165 junction cord (for 9268/9269; [V]NC to BNC, 1.5 m)
9166 junction cord (for 9268/9269; [V]NC to the clamp, 1.5 m)
9151-02/04 GP-IB coupling cable (2[m]/4[m])
9518-01 GP-IB the interface
9593 RS-232C the interface
9442 printers
9443-02 ACES is adapters (for 9442 EU) 9443-03 (USA)
9444 coupling cable (for 3511-50/9442)
1196 paper for the printer (25 m, 10 [rulonov]/1 collection for 9442)